Results 1 to 5 of 5

Thread: I.P Address

  1. #1
    Frequent Visitor
    Join Date
    Mar 2016
    Location
    Perth Western Australia
    Posts
    60

    I.P Address

    Hi
    Since the latest update my fusion dropped out and since then when our internet drops out my I.P Address shows as 0.0.0.0, then my wife has to go on the computer to the apex browse utility and reconfigure the IP address. are we missing something why we have to reset every time my internet goes out?
    Adrian

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    I would set a static ip in your situation. The problem could be from either side but figuring out why is difficult. A static ip would solve the problem and avoid the need to figure out why.

    Sent from my SM-G965U using Tapatalk

  3. #3
    Frequent Visitor
    Join Date
    Mar 2016
    Location
    Perth Western Australia
    Posts
    60
    G’day Zombie
    Thanks for time I’m not very good with computers so are you talking about DHCP mine is disabled do you mean enable this if so do you reboot the apex after changing it.
    Thanks Adrian

  4. #4
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    If your ip ie changing with DHCP disabled, then there is a much bigger problem at hand here like a seriously corrupt firmware or a hardware problem. Contact support.

    Sent from my SM-G965U using Tapatalk

  5. #5
    Frequent Visitor
    Join Date
    Mar 2016
    Location
    Perth Western Australia
    Posts
    60
    We tried a lot of things to get this up and running again DHCP was enabled but I have disabled it now and it’s been up and running for 12 hours so I have my fingers crossed

Similar Threads

  1. FMM module on address disappeared, then showed up as new module on address #13
    By thermoJoe in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 2
    Last Post: 10-12-2020, 18:19
  2. Can't access with IP address
    By hkgar in forum Apex Classic/Apex Lite/Apex Jr
    Replies: 1
    Last Post: 07-11-2017, 17:19
  3. Question: Aquabus Address 2 - is it ever used? Way to manually change AB address of a module?
    By speck55 in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 2
    Last Post: 06-01-2014, 05:06
  4. Help! IP Address
    By Leica in forum Networking & Internet Connectivity
    Replies: 2
    Last Post: 05-12-2014, 12:28
  5. Question: Is my WAN IP address same as my Gateway address?
    By powers2001 in forum Networking & Internet Connectivity
    Replies: 1
    Last Post: 03-01-2014, 13:40

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •