Recently added a new line to my return pump programming for a doorbell button feed mode. Here is my whole return pump programming:
Fallback ON
Set ON
If FeedA 000 Then OFF
If FeedD 000 Then OFF
If Sw6 CLOSED Then OFF
Defer 030:00 Then ON
If Time 16:00 to 16:05 Then OFF
When I do my maintenance (FeedD), the pump didn't come back on after the preset 60 minutes due to the 30 minute defer statement that I had added for the door bell feed mode. How can I rearrange or change the programming to isolate the defer for the doorbell button and not the other preset feed modes?
Bookmarks