what I'm after is this and not sure how to do it. I'm looking to have a container to fill up my water bucket to make my salt water. but looking it figure it out.
but this is my current setup
1. I have my RO unit
2. I then have reservoir pressure tank to put all my current RO water in came with my unit
3. then I have a selinod that goes from my line where the tap (this is a tap that I can get water from) is to my ATK.
and this works for me great.
But my issue is this right now if I drain my Tank then my ATK will just turnes off as there is no pressure. and if I dont go to my fusion my ATK will not be turn on till I do it manually.
Then comes my issues if I want to figure out how to add a 50G water bucket. how can I keep my PRESSURE tank full and put water that I make water in my 50G bucket.
would this be some fancy programming and with a couple more selinods?
Just not sure how to set this up to run automatically...
note my drawing skills stuck on my phone..
Sent from my SM-G950W using Tapatalk
Bookmarks