Ok to give a backstory here -last week I had a major catastrophe while I was on vacation. In short, what it appears is that somehow a piece broke off in a micro algae reactor, and caused a chain reaction in that 12 gallons of water was dumped onto the floor including an entire dump of the ATO reservoir (9 1/2 gallons). Yes I was alerted something was happening but somebody decided to suppress the alerts instead of waking me up.
I lost only one fish and a couple pieces of coral miraculously.
So after a couple of other issues I am giving up the tunze and installing the atk. That being said
1) Should I install an optic sensor in the ato to stop it from running the pump dry?
2) use it in conjunction with a leak detection system so that it won’t necessary start refilling the sump if it something like a reactor fails and spills water all over the place.
3) and if so-can I plug it in the same fmm unit as the ato? I see some issues possibly that it may cause the atk to not function properly.
TIA
Sent from my iPhone using Tapatalk
Bookmarks