Then I:
1. Unplugged the aquabus cable from one of the WXM leaving one connected to the apex
2. Removed all radion and vortech outlets from the output page in fusion (had to refresh the page and do this a couple times)
3. set the wxm to "wxm frequency 1"
4. factory reset all the Radions with EcoSmart Live
5. reset all the Vortechs via
holding the buttons,
6. select the 11 devices you want to connect to the first wxm
7. unplug the power from the remainder of ecotech devices (only 11 devices can be on at this step)
8. attach
all the radions in the module set up page
9. attached each vortech
one at a time same link as above
10. once the wxm was full, remove the aquabus cable from that wxm
11. unplug all radions and vortechs that are attached to the first wxm
12. plug in the remaining pumps and lights
12. plug the aquabus cable into the second wxm
13. set it to "WXM frequency 2"
14. repeat the steps to attach the rest of the devices
15. plug the first wxm back in and wait until the apex finds all the "missing" lights and pumps
I'm sure that I over did it with a few steps but it was better to start from scratch rather than continue to chase my tail. All that was left to do was program the lights and pumps to my specifications and I was off and running. If this helps only 1 person then it was worth me documenting it.
Bookmarks