I want to use my 0-10V Icecap controller to turn ON a Gyre for some period of time …say 15 second and then wait 5 seconds and get it to reverse for the same amount of time.
I think that I have set up everything to make it reverse (ie. Profile configurations #17 Time 0, 20, 20 intensity 0, 100 and #18 Sync Enable, Time 0, 20, 20 intensity 0, 100). It will reverse but my timing doesn’t follow the codes that I have tried.
I want to re-use part of some code that was graciously written for me but I just don’t understand how to turn something on after a delay.
I think that I want to stay away from OSC because I use an optical sensor as a trigger:
[ DumpControl ]
Set OFF
If Optical = CLOSED Then ON
Min Time 000:35 Then ON
And then I use the following, as well:
[ Step10_Up ]
Set OFF
If Output DumpControl = ON Then ON
Defer 000:15 Then ON
But now (I think that) I need to turn the pump on again to reverse the cycle. Do I simply build the following?
[ Step_Reverse ]
Set Off
Fallback OFF
If Output DumpControl = ON Then OFF
Defer 000:20 Then ON
Defer 000:15 then ON
And then it will turn back off again?
Bookmarks