Originally Posted by
DavidNZ
I can't really help with your figures, however I am in the same boat as you as I have a 1/4" sensor on my RODI and if I put it on the product water line, where I get 15LPH from (actually measured) I don't even get a reading from on the sensor, so I have put it on the line going into the RODI from the tap and I get 19LPH through it. Now if the sensor is correct, I only have 4LPH of waste water? Yeah, that isn't going to happen... I posted a thread here asking if anyone had this and if there was a way to calibrate the sensors and I got no replies. I am tempted to open a support ticket asking Neptune, but it hasn't really been that much of a concern to me as I only use it to tell me if there is flow or not through the line so Apex knows if the solenoid has failed (if flow is greater than 0 and solenoid is off)
Bookmarks