Results 1 to 3 of 3

Thread: Flow sensor 1.5"? And are they submersable?

  1. #1
    New User
    Join Date
    Dec 2017
    Location
    Toronto, Ontario
    Posts
    14

    Flow sensor 1.5"? And are they submersable?

    Will Neptune release 1.5" flow sensors anytime soon? For the other flow sensors, may they be submerged? Specifically the cable section?

  2. #2
    Frequent Visitor
    Join Date
    May 2014
    Location
    Portugal
    Posts
    389
    Hello,

    Not sure about the plans to release new flow sensors. I haven't seen anything.

    The current ones can not be submerged. The cable section I would not advise it so that you don't take the risk of condensation within the cable to flow to the sensor.

    All the best,
    Rui

  3. #3
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    The current flow meters are not submersible, so it's unlikely any new versions will be. Also, If they were to release new sizes, I would assume 3/4" and 1-1/4" would be their first targets since 3/4" is the most common return size and 1-1/4" is what they recommend for the COR.

    Sent from my SM-G965U using Tapatalk

Similar Threads

  1. Big pump 1.25" 2000gph... Flow sensor 2" 3k GPH? How to maximize this?
    By FrozenWater in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 2
    Last Post: 06-03-2020, 21:07
  2. Question: Flow sensor question: I'm using 3/4" PVC for return. Should I step down to 1/2" sensor, or step up to 1" sensor?
    By smartwater101 in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 1
    Last Post: 04-04-2019, 13:31
  3. 1/2" flow sensor: BSPP 1/2" to 1/2" push fit connector?
    By SteveW25561 in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 9
    Last Post: 03-14-2019, 17:14
  4. 3/4" to 1" flow sensor plumbing question
    By etpelle in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 0
    Last Post: 02-28-2019, 09:14
  5. Help! One of the of the two 1/2" FS-50 Flow Sensor on FLX_3 but the 2nd 1/2" flow Sensor will not display.
    By FoxTalbott in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 0
    Last Post: 12-26-2018, 04:03

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •