I have a 50 gallon saltwater mixing bin and I am trying to program the heater for it. This is an apex jr and it is not connected to fusion 24/7. I run a cable to it for programing via fusion and disconnect the cable afterwards. I rely on the feed buttons for control.
What I am trying to do is have the heater turned off except when a feed mode is activated. All feed modes are set for 4 hours. When the feed mode is activated I want the heater to turn on but only if the temp is below 76.5 and I want it to turn off when the temp hits 77.0. After the feed mode is over the heater should turn permanently off until I activate the feed mode again in preparation for my next water change. Is this possible, and if so how would I program it?
Bookmarks