So I am trying to set up a new auto water change system using 2 PMUP's. One to drain from the sump and the other to refill fresh SW from my SW container. I am not sure I am doing it correctly. Here is my programming:
Auto Water Change virtual outlet:
Fallback OFF
Set OFF
If DoW -----F- Then ON
If Time 11:15 to 11:35 Then ON
If ATK_Hi CLOSED Then OFF
If Output RetPump_2_3 = OFF Then OFF
If Leak CLOSED Then OFF
PMUP Drain:
Fallback OFF
Set OFF
If Output AutoWaterChg = ON Then ON
If AWC_Lo OPEN Then OFF
If Output LINKB_Refill = ON Then OFF
Defer 010:00 Then OFF
PMUP Refill:
Fallback OFF
Set OFF
If Output AutoWaterChg = ON Then ON
Defer 010:00 Then ON
If ATK_Lo CLOSED Then OFF
If ATK_Hi CLOSED Then OFF
Thanks in advance for any help!
Bookmarks