Folks, could I get a little help on diagnosing my ATK problem. I've noticed over the last couple of months my pump started shutting off and I'd get an ATK error. At first I thought it was running too long. I made some adjustments and still got errors, The pump continued to turn off, I'd get an error, but still unable to figure out why it was cutting off. I'd have to go into APEX and turn it back on. Now its gotten worse. The low water sensor is open and the pump will not turn on. The return pump chamber ran low last night. And now to get the pump to turn on, I have to manually turn it on through my phone.
What's up? Any thoughts?
Here's my programming for the ATK. This has not changed since I started using the ATO:
Fallback OFF
Set OFF
IF LoWtr1 OPEN Then ON
if HiWtr2 CLOSED Then OFF
If FeedD 000 Then OFF
When On > 006:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 060:00 Then OFF
If Output RetPump_2_3 = OFF Then OFF
Bookmarks