I dose vinegar. My dosing pump is controlled via Apex. I find that a few seconds after dosing vinegar, my pH goes down a little bit, then goes back to normal after a minute or so. I'm getting alerts due to this. I would prefer not to change my pH alert thresholds. I would like know if there is a way that I can programmatically disable the pH probe alerts for a minute just after dosing.
Alternatively, perhaps there is a way I can enable my PMUP pump at the same time that I'm vinegar dosing. Dosing pump (vinegar) and PMUP (RO + Kalkwasser mix) run on different programs. I would like to keep them separate (the rules are completely different), but would be great to turn on the pmup for a few seconds while dosing vinegar to sort of neutralize the effect of vinegar.
Thanks.
Bookmarks