Getting Possible Errant Email every hour

[BrianDrab]

I know this has been discussed before (research links are below) and I have tried the solutions. Ensuring that my email output was on Auto, taking out the Set ON from within the code of the port, rebooting the Apex (pushing the pin in for a second on the Apex unit), etc. however it continues to happen. I'm on the most recent version of firmware (5.04_7A18). Anything else I can try? I have absolutely nothing in the code for the email outlet.

From: Apex Fusion <[email protected]>
Sent: Monday, September 24, 2018 12:30 AM

Subject: Apex Fusion Alarm: apex
 
Date: 2018-09-24 00:29:59 -0400
Status: ON
Statement: Set ON

Research Topics
https://forum.neptunesystems.com/sho...ment%3A+Set+ON
https://forum.neptunesystems.com/sho...ment%3A+Set+ON
https://forum.neptunesystems.com/sho...ment%3A+Set+ON
https://forum.neptunesystems.com/sho...ment%3A+Set+ON

[zombie]

The email should start with Set OFF

Sent from my SM-G965U using Tapatalk

[RussM]

You can’t have an empty program - that’s not valid.

Put Set OFF in there.

[BrianDrab]

Thanks guys. I should have mentioned that Set OFF was in there with the same issue. I took it out (and it's still out) and have the same issue. I do get all my alerts with nothing in there (one example shown below) but I just put it back in since it's not a valid config.

From: Apex Fusion <[email protected]>
Sent: Monday, September 24, 2018 10:30 AM
Subject: Apex Fusion Alarm: apex
 
Date: 2018-09-24 10:29:59 -0400
Status: ON
Statement: If Salt < 29.0 Then ON (27.7)

Anything else I can try or do you think it's a bug in the newest firmware?

[zombie]

Thanks guys. I should have mentioned that Set OFF was in there with the same issue. I took it out (and it's still out) and have the same issue. I do get all my alerts with nothing in there (one example shown below) but I just put it back in since it's not a valid config.

From: Apex Fusion <[email protected]>
Sent: Monday, September 24, 2018 10:30 AM
Subject: Apex Fusion Alarm: apex
 
Date: 2018-09-24 10:29:59 -0400
Status: ON
Statement: If Salt < 29.0 Then ON (27.7)

Anything else I can try or do you think it's a bug in the newest firmware?

That particular alarm is set on the inputs tab under the conductivity probe.

Sent from my SM-G965U using Tapatalk