Hello folks,
I have a question/issue with my ramp profile i have created for the Cor-20. I'm sure I have something not set right, and want to get some feedback.
I would like the Cor to ramp up after each feed mode, and also anytime the pump comes back on from a off state.
Currently, the pump will not ramp up, and goes into straight 100% with the code I have listed below.
[Cor Programming]
Fallback COR_RAMP
Set COR_RAMP
tdata 00:00:00,0,0,100,0,0,0,0,0,0,0,0,0,0
If FeedA 000 Then 1
If FeedD 000 Then 1
If Output Water_Change = ON Then OFF
If Output Apex_Pwr = ON Then 1
[COR_RAMP] PROFILE
Name = COR_RAMP
Type = Ramp
Ramp Time = 5
Start Intensity = 1
End Intensity = 100
Pump is not being used in a closed loop system.
I have the Cor pump plugged into a Battery backup so the line (If Output Apex_Pwr = ON Then 1) is in case of power failure, set pump to 1%
I created a Switch for Water_Change to shut off all devices once the switch is set to on (If Output Water_Change = ON Then OFF).
Thanks in advance
Bookmarks