Results 1 to 2 of 2

Thread: Temp help

  1. #1
    New User
    Join Date
    Sep 2018
    Location
    Eastern
    Posts
    1

    Temp help

    I hooked up my new apex Jr and the temp calibration on my controller won’t go any higher the 35.5 degrees, I have my cobalt heater plugged into the energy bar. I also have fusion programmed for turn off at 78 degrees and turn on at 77 degrees. I have no way of knowing what the temp of my new tank is, Any thoughts??

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    Either you have it set to Celcius instead of Farenheit or the probe isn't properly seated and you are trying to calibrate an open circuit.

    Sent from my SM-G965U using Tapatalk

Similar Threads

  1. Question: COR-20 tile in fusion web page shows speed, watts and temp but temp is % ?
    By figuerres in forum COR-15 & COR-20 Pumps
    Replies: 1
    Last Post: 05-14-2018, 13:42
  2. dual temp probes temp variance
    By wildwilly1 in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 23
    Last Post: 10-09-2015, 10:23
  3. Replies: 3
    Last Post: 06-24-2015, 12:01
  4. Apex is sending emails for temp when temp is within set parameters
    By icc2515 in forum Networking & Internet Connectivity
    Replies: 6
    Last Post: 02-19-2015, 09:01
  5. Can I forgo the base temp and just use PM2 temp probe?
    By highergroove in forum Misc Apex Usage & Programming
    Replies: 2
    Last Post: 01-31-2015, 13:11

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •