,,,so I have a better idea on how it works. I am having issue with it after rerouting wires, etc and if I knew what each line did, I could troubleshoot myself :-) ALSO...when does it "error" which emails me.
I put notes behind the ones I think I know (correct if wrong):
Fallback OFF - Set to OFF if apex loses power?
Set OFF - Typically off unless programming says otherwisw
If ATO-L OPEN Then ON - If low Level Off (does not see water), then turn pump on
If ATO-H CLOSED Then OFF - If high Level Closed (sees water), then turn pump off
When On > 005:00 Then OFF - If pump runs more than 5 minutes, turn itself off
Defer 000:10 Then ON - It wont turn back on until its been off for at least 10 seconds
Defer 000:04 Then OFF - It wont turn off until its been off for at least 10 seconds
Min Time 060:00 Then OFF - ????
After letting Tasks reprogram ATK, it put this code in Email Alarm: If ATO-H CLOSED Then ON - Soooo, every time water level got to high sensor it turned off the pump BUT also emailed me of an Error?!? I took this line out...thoughts?
I also recall when I first setup ATK that the ATK kept turning itself off and sending me error emails...what line of programming did/does this? I recall my fix was to increase the time the pump could run before it was an error.
Bookmarks