Hello,
I just purchased & installed a Breakout Box for two float switches, one in my ATO reservoir & the other in my skimmer cup (mainly for email alarm notifications & skimmer shutoff). After BoB installation, the switches do not change status on my Fusion (or classic) dashboard when thrown in either direction. My ATO float switch is a horizontal Madison normally closed, and it's currently installed in that orientation so that it will open when the water level drops below the switch. However, even though that switch is currently closed the tile for that switch in Fusion remains showing open. The skimmer switch is not yet installed in the cup, but both switches test OK independently with my multimeter.
I'm using a terminal block for all BoB ground wires (thanks to @damonbrodie) and all the wiring & connections both independent and going through the BoB also check out OK on the multimeter. While connected to the multimeter I can throw either switch and see the change in continuity (resistance) on the multimeter, however while looking at Fusion on my laptop at the same time there still is no status change at the switch tile. I have no idea what could be wrong and don't know where to turn next - any assistance is greatly appreciated.
Thanks,
Jace K.
Bookmarks