Need Help: Turning Off and On Wavemakers based on Return Pump

[johnny9r]

I just setup my Apex on my new tank and my 2 Wave Makers hanging very high in my tank. I want to setup the wave makes to turn off when my return pump turns off and then turns back on 5 minutes after the return pump turns off. My fish room is in the basement and i don't want to leave the wave makers blowing all kinds of Air into tank if i'm downstairs and forget to turn them off when doing some maintenance.

Any help would be appreciated.

[Rui Manuel Gaspar]

Go into advanced mode of your wave makers (the outlet that control them) and add this in the bottom

If Output RETURN_MAIN = OFF Then OFF
Defer 005:00 Then ON

[OurCoralReef]

Go into advanced mode of your wave makers (the outlet that control them) and add this in the bottom

If Output RETURN_MAIN = OFF Then OFF
Defer 005:00 Then ON

Yes but shouldn’t it be

If Outlet (return outlet name) = OFF Then OFF
Defer 005:00 Then ON

(Corrected so no mistakes are made)

[RussM]

Yes but shouldn’t it be

If Outlet (return outlet name) OFF Then OFF
Defer 005:00 Then ON

No, the = is required in an If Output statement.

[OurCoralReef]

No, the = is required in an If Output statement.

Thanks
Are outlet and output interchangeable

[RussM]

Thanks
Are outlet and output interchangeable

Yes

9E3A6FC0-5748-4517-9375-9A746FCA4DA9.jpg

[OurCoralReef]

Thanks

[RussM]

What are you asking?

Never mind - wrong thread.

[OurCoralReef]

What are you asking?

Sorry wrong thread
thank you