Results 1 to 3 of 3

Thread: Turn off multiple outlets with "water change" command?

  1. #1
    Regular Vistor
    Join Date
    Aug 2018
    Location
    Germantown TN CST
    Posts
    19

    Turn off multiple outlets with "water change" command?

    Is there a way I can create a command that would turn off my filters, heaters, CO2, DOS, and power heads with one command? Each is on it's own outlet on the energy bar.

  2. #2
    Frequent Visitor
    Join Date
    Mar 2017
    Location
    Wellington, NZ
    Posts
    114
    Create a Virtual Outlet, I have one named Maintenance, Only code in there is Set OFF as I manually turn the slider ON to activate and then put in each device you want off this: If Output Maintenance = ON Then OFF

  3. #3
    Frequent Visitor
    Join Date
    Nov 2017
    Location
    Sydney Australia GMT+10
    Posts
    194
    I use one of the feed cycles for my maintenance. I set feed cycle B to 3600 secs (you can go to 64K) and just cancel it when my maintenance is done. I find this the simplest way to control what I want during maintenance from Apex Fusion.


    Sent from my iPad using Tapatalk

Similar Threads

  1. Math for figuring out 25gallon water change "Dose" profile
    By KantSekim in forum Apex Programming for Dosing, ATO, and AWC
    Replies: 2
    Last Post: 01-05-2022, 07:46
  2. Question: Alarm for "When" command ATK
    By Idahoreefer in forum Apex Programming for Dosing, ATO, and AWC
    Replies: 2
    Last Post: 05-03-2020, 07:12
  3. Question: How to add "And" command for kalk control
    By smohr123 in forum Misc Apex Usage & Programming
    Replies: 4
    Last Post: 12-10-2019, 09:41
  4. Program a switch to change a output from "auto" to "off"
    By saltaholic in forum Apex Programming for Dosing, ATO, and AWC
    Replies: 4
    Last Post: 07-30-2018, 21:36

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •