So I really was trying to avoid asking this.... but I can't seem to program my ATK unit with my DOS unit correctly after trying a few programs I found on here. What I want to do is dose 1.5 gallons and have the first sensor(Swx5_1) be the main water level sensor, and the second one above it as a back up(Swx5_2)
I Haven't changed anything from factory settings in the ATK, and this is my current program(copied from forum stickey) under my H20 top off dose pump:
Set OFF
If Swx5_1 CLOSED Then ON
If Swx5_2 OPEN Then OFF
Defer 002:00 Then ON
Min Time 010:00 Then OFF
Then under my dos wizard I added my estimated evaporation amount of 5678.1ML to dos between the hours of 15:20- 23:59
Currently both Swx5_1 is open, and Swx5_2 is open and no water is getting topped off and my sump water level is getting way to low.
Bookmarks