Hi everyone,
I have a lot of experience with the Neptune systems going way back and some experience with Apex. But I'm completely new to the profiles manus and I'm just having a really really hard time getting started. I have two Tunze 6095's connected to the Apex through variable ports 1/2 and I can see them just fine in Fusion. I can also the profiles pages and I know I need to link the profiles to the pumps so that they run the correct profile. What I would like to do is have pump one ramp up and down as fast as it can from from the lowest to the highest setting and have pump 2 just be the inverse. My understanding is that the ramps will take a minimum of 1 minutes (which is fine) and that the pumps shouldn't run lower than 35% (which is also fine). But how do I just set the pumps to ramp up and down continuously? Any help would be greatly appreciated. I haven't been able to find a simple example of this online.
Cheers,
FB
Bookmarks