Why will my DOS not run

[Bedrock^]

I have set up My DOS as a AWC and changing out 2 L or 2000 ML in a day. I set it up to do it while I was at work. I had to miss work today so I found that it was not running during the time that I had set it up for. I went into to check everything and found it was all programmed right and everything looks like it should so I set it for a new time and still didn’t run. After a 3rd time it still isnt running. Does anyone have any idea what I should do or check to see what is wrong? I need some help with this thing.

[RussM]

I have set up My DOS as a AWC and changing out 2 L or 2000 ML in a day. I set it up to do it while I was at work. I had to miss work today so I found that it was not running during the time that I had set it up for. I went into to check everything and found it was all programmed right and everything looks like it should so I set it for a new time and still didn’t run. After a 3rd time it still isnt running. Does anyone have any idea what I should do or check to see what is wrong? I need some help with this thing.

Press the two buttons on the DOS for a few seconds. If the pumps do not run, then most likely the DOS does not have 24vdc power.

[Bedrock^]

I'm sorry, they are running but wont run the program time I set up.

[zombie]

Post your program and verify that the outlet is in AUTO.

Sent from my SM-G965U using Tapatalk

[Bedrock^]

Well of course I have it on auto. I am deleteing the DOS out of the apex and trying to reload it and see how that does. If no good I will post the program.I had it set for 1300 to 2200 for 2000 ML though. I was using the DDR and it only holds 2 liters per side on it. OK going to try this real fast and see what happens.

[Bedrock^]

Yeah it is looking like the deleting and unplugging the DOS might have work. It has been working as of 4 rounds as of now. I guess I will see what happens over night by the morning anyways. Just kicked on again so its still looking good so far.