I switched to the new 2016 APEX and after moving one of my WXM over, fusion alerted me that it needed to be updated due to an (OLD) update. I pushed the update and the module was responding but when it said the update was complete, I refreshed the module page on fusion and it still showed (OLD). I left it alone for 20 minutes thinking that it was still updating and when I came back to check on the status, (OLD) was still there. I then tried to push an RF Update and then another update and even though fusion said these were complete, they were not. Now that I have done this a few times, the status light on the WXM is now blinking and I can't get it to even register with the Apex with plugging it in via the aquabus cable.
What do I do???
Bookmarks