I've had my ATk for about 2 months, everything was going flawlessly until 3 nights ago at around midnight when I noticed that the ATK was running way longer than it should. Generally it would run for about a minute. However, on this night, at this time, it ran for a full 8 minutes and then it shut off when the float valve kicked in (the final safety measure). The system defaulted to OFF and I've had to manually turn on and off the top off. Since then, I've inspected the unit, cleaned it using a cloth, and adjusted settings hoping to get it out of it's funk. I'm not sure what is happening but it always running for the max time and then defaulting from AUTO to OFF. Not sure how to fix this.
Here are my settings:
Fallback OFF
Set OFF
If ATOlow OPEN Then ON
If ATOhi CLOSED Then OFF
When On > 008:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 020:00 Then OFF
I actually just reduced the Min Time from 30 to 20, thinking maybe the evaporation was too much for and the water was getting too low so the unit was over filling. Considering it just ran for the full 8 again, I'm going to put it back up to 30 minutes.
Any help would be appreciated.
Bookmarks