Hi all,
I wrote some months a thread about my many problems with last FW of apex classic, but was removed..
I have the last 4.53, 4.53_AB17
I have may times updated the boot loader, but the issue that I have is still present.
I have the "power monitor" enabled, all my apex is connected on a UPS, only the 12V for power monitoring is connected directly to the utility.
At ends of October I have a big power outage in my area, for many hours. The UPS was drained off and all the aquarium was powered off. When the power line was reactivated, the Apex hangs, all device blinking orange, display blank and the CPU not complete the boot. And this problem I have expericenced every time I try to simulate this condition.
To start the CPU I have to:
- disconnect 12V from CPU,
- disconnect the Aquabus from CPU (to not powering it with powerbar)
- disconnect the LAN cable
- connect 12V and powering up the CPU
- connect the aquabus and wait the green led fixed on all the devices
- connect the LAN cable.
I'm still waiting for a response or a new FW release.... but nothing. One year and more from the last upgrade. The developing is clearly focused only on new apex model.
Last change: my idea is to make a backup of my configuration (many devices, many virtual outputs, very complex programming) and after this, try a factory-full reset and a reloading the configuration.
Any another idea to resolve? Somebody else is experiencing my issue?
Bookmarks