Had to replace my Apex EL due to probe port failure (kudos to Neptune for the quick help).
I had saved my config file from the old unit and loaded it into the new one thinking I would be up and running very quick.
The new EL took the file, then rebooted as expected. But things were not good. I had no control over outlets and the fan in the EB832 kept cycling on and off---nothing was right.
Tried reloading the file, again it took it, but same results.
So I reset the unit to default and spent the next few hours reprogramming from scratch. That sucked.
So, any ideas why my saved config would load, but not work?
I feel the file was ok, because before my original unit failed I had tested the file by reloading it on the original and it was fine.
I am past the issue, but just trying to understand what happened in case I am ever in a similar situation.
Bookmarks