I have a light strip installed inside my cabinet where the sump is located. Light is used for utility purposes to provide light when I'm working on the sump or water changes.
I have installed a float switch in the filter floss & felt chamber in the sump. in about 4 days, the 100 micron pad will be clogged of stuff and slows the water flow down to a trickle. I'll know I have to change it when I hear the water dripping as it over flows the chamber.
I'd like to use the float switch to detect when the water in chamber has been slowed down to a trickle - float switch goes from CLOSED to OPEN. When this happens I would like to cause the under cabinet light to flash off and on until the condition has be resolved.
I have FEEDC setup to turn on the undercab light for water changes. Here is to code.
Fallback OFF
Set OFF
If FeedC 000 Then ON
Any ideas what the code would look like to cause my light to flash?
Bookmarks