Looking for something to support DOS tubing from kinking when having to bend it at 90°. Closest I found were 90° supports for people tubing but smallest was 3/4 I need 1/4. Any suggestions?
Looking for something to support DOS tubing from kinking when having to bend it at 90°. Closest I found were 90° supports for people tubing but smallest was 3/4 I need 1/4. Any suggestions?
RODI tubing and connectors is what I run mine inside of.
Chad
U use them for ur dos tubing with no issues?
Argh! To be honest i was thinking of Trident tubing (sample/waste). Wow i'm tired! However I do use drip tubing to run long lengths from my DOS. A small section of the flexible tubing that NS supplies goes on the DOS head fitting, then a small barbed fitting from this tubing to the Drip tubing to my destination is what I've run.
Fo
Chad
Tubing isn't meant to be bent at a sharp angle. Route the tubing so it has a smooth curve.
If you really need to have a fairly tight bend, you can use 90-gegree quick-disconnect fittings.
https://www.homedepot.com/p/1-4-in-P...3279/300753459
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Posting Permissions
Reply With Quote
Bookmarks