Results 1 to 2 of 2

Thread: Confusion about variable outputs in the display and the wizard

  1. #1
    Regular Vistor
    Join Date
    Dec 2013
    Location
    Peoria, AZ
    Posts
    44

    Confusion about variable outputs in the display and the wizard

    I have two tunze streams attached to my Apex. One on a VDM, one on the base unit. Both with profiles setup in the wizard. Why does one show up in the fusion display as TBL, but the other gives me the current % operation speed? The VAR_TUNZEL is attached to the apex. The programming for both is virtually the same. If I look in basic, it's just a fallback 50 followed by tdata statements.


  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    It's just a weird quirk with the firmware. The VDM always shows percent and the base ports show the profile name being used (or tbl if the wizard is active). I wish they would just make them all show percent or let you pick.

    Sent from my SM-G965U using Tapatalk

Similar Threads

  1. Fusion feature request - Variable Virtual Outputs
    By spyder66 in forum A2 Apex/ApexEL and A3 Apex Pro/Apex/Apex Jr
    Replies: 0
    Last Post: 10-16-2017, 13:37
  2. Programming Confusion - Help Please
    By Phil in forum Misc Apex Usage & Programming
    Replies: 2
    Last Post: 05-30-2017, 11:06
  3. Help! apex vo confusion
    By rschneid in forum Misc Apex Usage & Programming
    Replies: 18
    Last Post: 09-25-2014, 05:56
  4. Replies: 3
    Last Post: 12-31-2013, 21:06
  5. Max current draw on variable 0-10V outputs
    By AlanM in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 1
    Last Post: 07-01-2013, 19:00

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •