Results 1 to 3 of 3

Thread: Create virtual outlet

  1. #1
    Frequent Visitor
    Join Date
    Nov 2013
    Location
    Michigan
    Posts
    128

    Create virtual outlet

    I need a virtual outlet. I click, on the dashboard, configuration, module setup. Then create module type lunar. System processes but than there is no new module. DoI need to change the "start control address"?

    I have the Classic. I have done other virtual outlets but not having any success this time.

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    11,604
    You need to use a start control address that you have not already used and the control addresses cannot exceed A15, B15 etc. No module will show up when you create the VOs.

    Sent from my SM-G965U using Tapatalk

  3. #3
    Master Control Freak RussM's Avatar
    Join Date
    Dec 2012
    Location
    California - US Pacific
    Posts
    17,681
    The available control addresses to use are actually A1-A16, B1-B16, etc. (up to P1-P16).

    When adding a dummy LunarSim to get a single VO, you can use any address within these ranges as long as it has not already been used.
    I'm not a Neptune support rep. Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •