Results 1 to 3 of 3

Thread: Output configuration for CAL Reactor PH probe

  1. #1
    Regular Vistor
    Join Date
    Dec 2017
    Location
    Virginia
    Posts
    16

    Output configuration for CAL Reactor PH probe

    I am trying to program one of my outlets on the 832 bar for my carbon doser. My PM1 module is active, up to date and the probe is calibrated and reading. When I go to the outlet to configure, select PH probe, select the correct probe for the reactor and set my HI/LOW parameters. Once i hit the cloud to apply, i get an error which displays this "//error line 2 - valid keywords following If are Temp, pH, ORP, DO, Cond, Salt, Par, Feed, SwX, FLX, Error, Power, Sun, or Moon // I CalcR > 7.5 then ON" Has anyone seen this error or know what the possible issue would be?

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    Change the name of that pH probe. Sometimes the system doesn't like the default name.

    Sent from my SM-G965U using Tapatalk

  3. #3
    Regular Vistor
    Join Date
    Dec 2017
    Location
    Virginia
    Posts
    16
    I figured out that I had to go into the TASK tab and configure the Probe alarm min / max to but lower in on order to achieve the desired configuration on the outlet. Once I did that it accepted the change.

Similar Threads

  1. Question: Local Output Configuration vs Fusion Output Configuration 2016
    By FoxTalbott in forum A2 Apex/ApexEL and A3 Apex Pro/Apex/Apex Jr
    Replies: 2
    Last Post: 11-07-2017, 06:39
  2. Review My Program Co2 regulator for cal reactor
    By charliethetuna in forum Apex Classic/Apex Lite/Apex Jr
    Replies: 16
    Last Post: 08-26-2014, 15:11
  3. Question: Cal reactor ph probe
    By charliethetuna in forum Apex Classic/Apex Lite/Apex Jr
    Replies: 10
    Last Post: 08-05-2014, 05:45
  4. Need Assistance with Cal. Reactor Program
    By rsxjh in forum Apex Classic/Apex Lite/Apex Jr
    Replies: 8
    Last Post: 01-15-2014, 09:37
  5. Need help with cal. Reactor
    By Cltboi in forum Apex Programming for Dosing, ATO, and AWC
    Replies: 2
    Last Post: 08-17-2013, 22:33

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •