I am trying to program one of my outlets on the 832 bar for my carbon doser. My PM1 module is active, up to date and the probe is calibrated and reading. When I go to the outlet to configure, select PH probe, select the correct probe for the reactor and set my HI/LOW parameters. Once i hit the cloud to apply, i get an error which displays this "//error line 2 - valid keywords following If are Temp, pH, ORP, DO, Cond, Salt, Par, Feed, SwX, FLX, Error, Power, Sun, or Moon // I CalcR > 7.5 then ON" Has anyone seen this error or know what the possible issue would be?
Bookmarks