Hey guys,
I finally built my Control Cabinet and man is it beautiful. Anyways, I had to grab a PM1 Module as the Temp probe wasn't long enough. I powered it off my FMM Module and plugged the probe into the PM1. Went ahead and disabled the original temp port and enabled the new one on my dashboard.
Well now the heater is on when set in automatic mode on my dashboard even though it is above my maximum tolerances. Too add to all this, I keep getting an error when I try to enable the log for it as well.
Any help would be appreciated as I'm sure its an easy fix, but for the last 90 minutes I cant seem to figure it out
Please see below for error message.
Thanks for helping and taking the time to read this in advance and Happy Reefing!
//Error: line 2 - Valid keywords following If are Temp, pH, ORP, DO, Cond, Salt, Par, Feed, SwX, FLx, Error, Power, Sun, or Moon // If Tmp < 78 Then ON
Bookmarks