ATO Code

[tdhight]

Still fairly new at this. I have the Smart ATO micro connected to the energy bar. Issue I am trying to solve is the ATO's built in fail safes that will sometimes go off if I take too much water out when doing something so I then have to go into Fusion, switch off then back on. I was thinking using OSC code to have the ATO run for one minute every hour which should alleviate most of this issue. Do you see any issues with this or my code?

ATO
Fallback ON
OSC 000:00/001:00/059:00
If Output vMaint = ON Then OFF

[zombie]

Looks fine.

Sent from my SM-G965U using Tapatalk

[tdhight]

Thanks!

Sent from my SM-G955U using Tapatalk

[tdhight]

So, After u upload apex keeps throwing a "then off" after the OSC code which I think is having opposite effect where it is off for 3min then on for 177. What am. I missing to get it to be on for 3 then off for 177?

Fallback ON
OSC 000:00/003:00/177:00 Then OFF
If Output vMaint = ON Then OFF


Sent from my SM-G955U using Tapatalk

[zombie]

So, After u upload apex keeps throwing a "then off" after the OSC code which I think is having opposite effect where it is off for 3min then on for 177. What am. I missing to get it to be on for 3 then off for 177?

Fallback ON
OSC 000:00/003:00/177:00 Then OFF
If Output vMaint = ON Then OFF


Sent from my SM-G955U using Tapatalk

You want then ON

Sent from my SM-G965U using Tapatalk

[tdhight]

Dang it, that simple. Thanks!

Sent from my SM-G955U using Tapatalk