14 years in the hobby and finally started buying Neptune products, started out with the other stuff that is no longer being produced.
I bought a COR 20 pump to replace a different failed pump about 4 months ago.
I was running it stand alone external and had issues received parts and no fix, finally got it figured out. The soft start is too strong/fast, but I can get it to go if I start it low and ramp up manually to my desired speed.
Now I have upgraded the controller to the an Apex and have the same startup problem, Fusion has helped and says it is in a run dry fault. But if I graph it at a low start point It goes.
I see there is a way to program this to occur automatically at startup but where do I get information about the coding? Key words? Scripts? Etc?
Can someone point me to a resource, or provide an example to try?
Ive seen a few things that seem close.
What I’m looking for is:
Powerup / start up / maintenance?
start at 5% then ramp up to the desired level on the graph
over about 1 minute.
Thanks
Bookmarks