I use my manual display a lot more than I use fusion.
Today I noticed my Apex classic display was froze when I tried to go to feed mode like I normally do. The display was there (can see the text and it was backlit) but no buttons would work. I unplugged the display then plugged it back in after 5 minutes. When plugged back in the display remained black (not backlit) and it the outlets would not respond through Apex Fusion and the EB8 and some other modules were blinking green. Unplugging the display and leaving it unplugged turned the EB8's solid green and I could access everything through the APEX again.
Why would the display cause other auqubus connections to fail? Can my display be fixed?
Bookmarks