Hi everybody, I'm bit confused regarding programming variable speed port which I'm using to control DC pump over AQLink A1 (it is return pump). As I understand I can use "Profile programs" or pump visual configuration on varspeed port. But I think none of this is suitable for programe I need.
My idea is very simple. I would like to run my pump for 90% all day but during Feed cycles I would like to set it to 42% (thats the threshold where pump not siphoning back to supm but on the other side not pumping water to DT).
Is there anything like:
Fallback ON
SET 90
If FeedA 000 then SET 42
?
I didnt find if this is working or not. I also understand that variable "SPEED" also not working.
So do you have any idea how to achieve this? Just simply control power output on VarSpeed Port.
Thank you very much
Bookmarks