My ATK just died.
On disassembly it has melted.
I will note when working the pmup would only run for a few seconds very frequently and this was a new behavior that started after updating the module.
Previously it would run for a minute or so but much less frequently.
In both circumstances the sump water level was maintained,
I have an Apex classic
Current ATK program
Fallback OFF
Set OFF
If Swx8_1 OPEN Then ON
If Swx8_2 CLOSED Then OFF
If Sw1 CLOSED Then OFF
Defer 001:00 Then ON
Swx are the optical sensors
Sw is a reservoir float switch to the breakout box.
This is the generic programming
Is this Ok?
I’m not sure what the defer is for
Thanks
Bookmarks