So most of below was the default program that was populated when I had set up the ATO -
The exception is the optic sensor statement that I added -the question is -how do I keep it in the off state if the optical sensor is open? -or at least for 8 hrs or s.
I can tell that it bypasses the statement by going to the lowatk statement next and executing that
TIA
Lawrence
Fallback OFF
Set OFF
If ATO_OP OPEN Then OFF
If LOWATK OPEN Then ON
If HI_ATK CLOSED Then OFF
When On > 005:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 060:00 Then OFF
Sent from my iPhone using Tapatalk
Bookmarks