So I have an interim frag tank set up and I'm using an Apex Classic and an ATK to top things off. The delima is the amount of water that would evaporate between the high and low sensors in a 20 long would lead to significant swings. Here's what I would like to do but can't seem to nail down. I am using an outlet and not the power on the FMM as the reservoir is too far from the temporary location of my frag tank.
Code:
Fallback OFF
Set OFF
If Swx6_1 OPEN Then OFF
Defer 240:00 Then ON
If Swx6_1 CLOSED Then ON
Defer 000:05 Then OFF
I tried:
Code:
Fallback OFF
Set OFF
If Swx6_1 OPEN Defer 240:00 Then ON
If Swx6_1 CLOSED Defer 000:05 Then OFF
HOWEVER - When I save it and go back into the program I get:
Code:
Fallback OFF
Set OFF
If Swx6_1 OPEN Then OFF
If Swx6_1 CLOSED Then OFF
I would like to only use the high sensor (Swx6_1) and allow a few hours to pass before the outlet actually turns on this will allow for a bit more evaporation to happen but at the same time keep it pretty tight. Long story short, what I've tried is not working. Any advice is greatly appreciated.
Bookmarks