A few people asked for this and I had a need for one.
So here it is
https://www.thingiverse.com/thing:4196646
Print it on its back and with a brim with supports to ensure its strong and water tight on the layers. do not print at 100% as this will weaken the model (research it!)
added a stop for safety too. Should allow a range from 80-100 degrees to allow for angling at the glass or rock if needed. also enough room for the cable to sit still
1f308dbd-e128-4d24-834c-72abdaa78944.jpg
76795971-3f82-4bc8-84f6-11522308bb04.jpg
Bookmarks