I have backed out my programming to the absolute simplest in order to test my ATO
Fallback OFF
Set OFF
If ATOSw3 OPEN Then ON
I had additional statements in there for a high level float switch as well as a defer statement to deal with float bounce. I dumbed it down to the above. I have no virtual outlet programming at all.
Here is the problem I'm having. The output of the outlet bounces on and off very quickly, like once a second or less. When I have it set to auto. The float switch is not bouncing as the water level is completely below the level of the switch. If I change from "auto" to On the output stays on. Therefore I believe I can rule out the relay attached to the physical outlet.
What would cause the float switch input to be so erratic? As I believe that might be the problem.
Thanks in advance
John
Bookmarks