If I were to want the led always on which wires would i switch?
If I were to want the led always on which wires would i switch?
From what I described above, just changing the + power from the left white wire to the red wire would do it. Then cap off the left blue and left white wires.
I ended up switching lights again, would you mind helping me with the wiring? I think I'm pretty close on this one. These were straight from China and didn't have any wiring diagram. 15499354686076829704024176670234.jpg
Without a wiring diagram, it's only a guess. I would guess that the black and red leads should go to the power supply and illuminate the switch constantly. One blue lead and matching yellow lead to the BOB. No idea if it's going to be normally open or normally closed As I said, just a guess, and if it's wrong, you could potentially damage your Apex.
I think I found it. Let me know if this helpsScreenshot_20190212-130155.jpg
With this model, I don't think you can get the switch to toggle ON and the light to also come on at the same time, without also sending 24V to the BOB, which you don't want to do. Red and black leads to the power supply, leads 3 and 4 to the BOB.
Well thank you again for all your help, I have a request in for a witiwi diagram for my specific button. If the diagram changes I'll post it here.
I was able to get a wiring diagram, any luck with this one?Screenshot_20190212-204316.jpg
Bookmarks