Results 1 to 3 of 3

Thread: Overflow Pumps

  1. #1
    New User
    Join Date
    Aug 2018
    Location
    PA
    Posts
    2

    Overflow Pumps

    Hello,

    I have two overflows that have pumps attached to them to make sure the water doesn't lose its siphon. The problem I am running into is that my overflow water levels will drop and lose the vacuum when I enter feeding mode. I currently have the pumps turning on 3 minutes every hour but I want to add in code to make is so that they turn on for a few minutes after the feeding. I figure you guys could help me out as I have failed at getting it to work. I assume I am missing an "On" in the middle but I am unsure of what to put there.

    Fallback ONSet ON
    If FeedA 000 Then OFF
    Min Time 003:00 Then OFF
    OSC 000:00/003:00/057:00 Then ON

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    You want this

    Fallback ON
    OSC 000:00/003:00/057:00 Then ON
    If FeedA 003 Then ON
    If FeedA 000 Then OFF



    Sent from my SM-G965U using Tapatalk

  3. #3
    New User
    Join Date
    Aug 2018
    Location
    PA
    Posts
    2
    Thank you very much!

Similar Threads

  1. Overflow Sensor
    By ubiq in forum DIY
    Replies: 4
    Last Post: 03-31-2022, 17:00
  2. Help skimmer overflow
    By jamiequ in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 5
    Last Post: 05-31-2018, 10:51
  3. DT Overflow Prevention Programing
    By DrBoxedWine in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 29
    Last Post: 01-13-2015, 09:08
  4. Overflow shutoff?
    By djbetterly in forum Misc Apex Usage & Programming
    Replies: 6
    Last Post: 08-24-2014, 17:42
  5. Overflow problem
    By bushdoc in forum EnergyBars 832 / 632 / 8 / 6 / 4
    Replies: 4
    Last Post: 12-11-2013, 05:10

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •