I'm using a DOS for AWC and every so often it misses a dose for no reason.
Profile Configuration:
Name: WtrChange
Type: Dose
Rate: 250ml /min
Pump Direction: Forward
Per Dose Amount: 375ml
Dose Intervals: 600 seconds
Dose Count: 5
NSWDos
Fallback OFF
Set OFF
If Time 20:00 to 21:30 Then WtrChange
If Time 10:00 to 11:30 Then WtrChange
If Output vNSWLo = ON Then OFF
If Output vHi = ON Then OFF
If Output vBsmtLeak = ON Then OFF
If Output vTankLeak = ON Then OFF
OSWDos
Fallback OFF
Set OFF
If Time 20:00 to 21:30 Then WtrChange
If Time 10:00 to 11:30 Then WtrChange
If Output vNSWLo = ON Then OFF
If Output vHi = ON Then OFF
If Output vTankLeak = ON Then OFF
If Output vBsmtLeak = ON Then OFF
It appeared in this instance to have missed the NSWDos at 10:11:33 for some reason. From the code, the only thing that could have stopped the AWC was either running out of NSW (NSWLo), my sump being too high (vHi), or a leak. The thing is that if any of them were triggered, it should have stopped both NSWDos & OSWDos and not just one or the other.
DOS Log.JPG
DOS Graph.JPG
Output Log.JPG
Bookmarks