Hi folks, so I added my
wavs with a simple schedule and thought I’d set warnings up via email, but today I seem to be getting emails galore and I’m not sure why. Anyone with any ideas? B835092B-4BE4-4B22-831D-435BD0E1D597.jpg
Hi folks, so I added my
wavs with a simple schedule and thought I’d set warnings up via email, but today I seem to be getting emails galore and I’m not sure why. Anyone with any ideas? B835092B-4BE4-4B22-831D-435BD0E1D597.jpg
Do you see any error status on the WAV tile on the Dashboard? Like POSERR, STALL, etc?
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Hi Russ, thank you for the reply, there was (poserr) but I cleared them via the classic dashboard yesterday so before these notifications! The notifications started this morning and still continue every 20 mins or so, but no warnings on fusion they seem to be running fine according to fusion control panel!
Heres a grab from my fusion dash! Screen Shot 2019-01-15 at 19.14.44.png
Can anyone help?
Add this to your email. This suppresses weird alerts like this so you are only alerted when an alarm is really active.
Defer 000:30 Then ON
Defer 000:10 Then OFF
Sent from my SM-G965U using Tapatalk
Ah brilliant, thank you for that, and the work you and the other guy do on here, it’s above and beyond! Thanks
Can I just ask RE: post 6
what does the coding mean?
Is there a good place to learn the code as i would like to try and learn what im doing?
What can i add to my atk so that when i hit feed mode a , again i dont get loads of warnings?
Many thanks again!
It means wait until an alarm has been continously on for 30 seconds before actually turning ON, and vice versa for OFF except only 10 seconds there. Makes it so noise spikes and splashes don't give you nuisance alarms.
Best place to learn is to read the comprehensive users manual in its entirety as well as the module user manuals and quick start guides for any modules you own. After that, the stickys are a must to read. If you want more info than that, browsing the forums and lurking to see answers to other peoples questions helps a ton towards reaching control freak levels of knowledge.
High level alarms need to be suppressed using a virtual outlet like so
HighSump
Set OFF
If HighSw CLOSED Then ON
If Output ReturnName = OFF Then OFF
Defer 005:00 Then ON
Email replace high level alarm with
If Output HighSump = ON Then ON
Sent from my SM-G965U using Tapatalk
Brilliant, thanks again ill take a look!
Bookmarks