I have 2 300 watt heaters in my sump. I 1 plugged into my eb8 and the other plugged into the 832. I have both the heaters set to 80 and the apex programmed the following.
Fallback OFF
If Tmp < 79.0 Then ON
If Tmp > 79.4 Then OFF
What i noticed is the heater comes on for a few minutes drawing about 300 watts on the apex then drops back to 3-5 watts. The issue is the tank is losing temp even though the outlets are on. So as a test i plugged both heaters into an extension cord, taking the apex out of the mix and the tank gained over a degree. I plugged the heaters back into different outlets on the apex and as you can see the temp is dropping already.
temp.JPG
Thoughts!!!
Bookmarks