Are tokens not being used anymore or is it just me ?? If my Apex disconnects, it's a PITA to reconnect ... keeps asking for a token ??
Sent from my SM-G935U using Tapatalk
Are tokens not being used anymore or is it just me ?? If my Apex disconnects, it's a PITA to reconnect ... keeps asking for a token ??
Sent from my SM-G935U using Tapatalk
Thanks
Sent from my SM-G935U using Tapatalk
I am,waiting,for dam,token to,get set up don't understand please,help
Ttrying to link apex to,fusion thought this was done when set up
Not starting,out very good getting very angry at,this system,already
Are you following the get started guide?
Sent from my iPhone using Tapatalk Pro
I followed every step,and,still will,not link to,my apex with out dam token frustrated to no end
- - - Updated - - -
Both the 832 and the,controller are solid,orange
Which one of these three options do you see for the Fusion Tile show when you are in Apex Local. (This tile is near the Feed cycles and media tile)
Apex Fusion: OK
Apex Fusion: No Communication
Apex Fusion: Generate Link Token
If it says generate link token click on the tile and enter the code into Fusion.
Jon
Im having the same issue. Keeps asking me for token when trying to link.
- - - Updated - - -
Thats the issue. Where do we get this code from?
Have you followed the directions on page 24 of the Comprehensive Reference Manual?
https://www.neptunesystems.com/downl...nce_Manual.pdf
If this is a 2016 Apex, you do not need a token.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Not sure if you are still having a problem, but rebooting the apex solved my issue of linking to Fusion. After I rebooted, Iwas not prompted for a token.
Bookmarks