COR20 and fusion low voltage problem

[aaronfelt]

Hey all. Little emergency here. I plugged my COR20 into my EB832 apparently against their wishes which I didn’t find instructions for until now trying to resolve this, and seem to have tripped a low voltage alarm on my COR20 that I can’t clear. My pump now will not run. I was adjusting IQ points and schedule of power in the Cor module of fusion when it tripped and now wont come on. How do I clear the alarm and get this thing started again or did it just cook itself? It’s been running one week.


Sent from my iPhone using Tapatalk Pro

[aaronfelt]

Welp if this happens to anyone else.... check your power brick /facepalm. Apparently the cord had slipped out. I didn’t realize the aqua bus would continue to power the driver which is why it was light up even though it had no power for the pump. Fusion continued to say it was dumping a few watts into the pump and that it was going at a few hundred RPM which I doubt was true.


Sent from my iPhone using Tapatalk Pro