The way my reservoir is setup and my sump it’s possible for my ATO to siphon in more water into my sump than I want it to. Yea I know the float will stop it but that more than I want.
so I’m installing a solenoid
I want it to open when the low level sensor opens
and closes when it’s done
below is my programming
my solenoid is on my eb832, base1
thanks
Fallback OFF
Set OFF
If AtkLow OPEN Then ON
If AtkHig CLOSED Then OFF
If ResLow OPEN Then OFF
When On > 002:00 Then OFF
Defer 010:00 Then ON
Min Time 050:00 Then OFF
Bookmarks